DinizApp/Electronics Center
-
Electronics
Electronics
Eletrônica -
Always use analog multimeter to test this component
Always use analog multimeter to test this component
Para testar este componente sempre use o multímetro analógico -
Select the x1 scale
Select the x1 scale
Selecione a escala de x1 -
Take the probes to measure the SCR
Take the probes to measure the SCR
Pegue as ponteiras para medir o SCR -
Put the black probe on anode and the red probe on cathode. To test the shot, close a contact between anode and gate by clicking the trigger. The multimeter should show a low resistance.
Put the black probe on anode and the red probe on cathode. To test the shot, close a contact between anode and gate by clicking the trigger. The multimeter should show a low resistance.
Coloque a ponteira preta no anodo e a vermelha no catodo, para testar o disparo feche um curto entre o anodo e o gate clicando em disparo. O multimetro deverá mostrar uma resistência baixa.
No more segments to load.
Loading more segments…
© 2009-2024 WebTranslateIt Software S.L. All rights reserved.
Terms of Service
·
Privacy Policy
·
Security Policy