DinizApp/Electronics Center
-
Electronics
Electronics
Eletrônica -
Always use analog multimeter to test this component
Always use analog multimeter to test this component
Para testar este componente sempre use o multímetro analógico -
Select the x1 scale
Select the x1 scale
Selecione a escala de x1 -
Take the probes to measure the SCR
Take the probes to measure the SCR
Pegue as ponteiras para medir o SCR -
Put the black probe on anode and the red probe on cathode. To test the shot, close a contact between anode and gate by clicking the trigger. The multimeter should show a low resistance.
Put the black probe on anode and the red probe on cathode. To test the shot, close a contact between anode and gate by clicking the trigger. The multimeter should show a low resistance.
Coloque a ponteira preta no anodo e a vermelha no catodo, para testar o disparo feche um curto entre o anodo e o gate clicando em disparo. O multimetro deverá mostrar uma resistência baixa. -
No reading should appear with inverted probes.
No reading should appear with inverted probes.
Se inverter as ponteiras não devemos obter nenhuma leitura. -
Putting the black probe on gate and the red probe on cathode, the reading should show a low resistance.
Putting the black probe on gate and the red probe on cathode, the reading should show a low resistance.
Colocando a ponteira preta no gate e a ponteira vermelha no catodo temos que obter uma leitura de baixa resistência. -
In other positions should mark infinite.
In other positions should mark infinite.
Nas outras posições deverá marcar infinito. -
SCR measurement
SCR measurement
Medição de SCR -
Shoot
Shoot
Disparo
Il n’a plus de segments à afficher.
Chargement d’autres segments en cours…
© 2009-2024 WebTranslateIt Software S.L. Tous droits réservés.
Termes d’utilisation
·
Politique de confidentialité
·
Politique de sécurité